I had a D-Link USB wireless adapter)receiver installed successfully. Due to some problems setting up a home network I ran the unistall program to remove the driver.

I went to reinstall the driver from the factory supplied CD and the InstallShield starts up and on the screen following where it specifies the location and icon name it starts to try to load the files. At that point in time the floppy disk drive makes a noise like it is trying to read a floppy (which of course is empty since this is a CD) and immediately comes up with a window labled "Feature transfer error". The message in this window is "Error -1612 The installation source for this product is not available. Verify that the source exists and that you can access it."

When I click the OK icon on that screen it goes back to the InstallShield screen which says the wizard was interupted before the Air USB utility could be completely installed.

I also downloaded the driver/utility program from the D-link site and ran setup.exe with the same exact results. I checked Device Manager and there is no network adapter installed for this D-Link USB device (DWL-122). Hope someone has some ideas on this. Thanks

You may have some 'leftovers' in your drive.

Try deleting, for instance:

c:\Program Files\D-Link

Then run a reg cleaner.

BUT BACK THINGS UP FIRST